Installation; Installing A 60-Bay Unit - Bosch DSA E‑Series Installation Manual

20 en | Installation
4

Installation

4.1

Installing a 60-bay unit

You can install the unit in a four-post rack or system cabinet.
Observe the following:
–
–
–
Notice!
When installing the units, load the cabinet so as not to make it top-heavy. One approach is to
place the controller-unit in the middle portion of the cabinet while allowing room for
expansion units to be placed above and below the controller unit.
To install a 60-bay controller unit or expansion unit:
1.
2.
3.
2020-05 | V2 | DOC
You can install the unit in either a square-hole or round-hole rack.
If you are installing the unit in a cabinet not provided by Bosch:
– Ensure that the rack is adequate for the weight and size of the unit to be installed.
– Calculate the thermal output of your equipment and compare the results with the
target system cabinet's thermal rating. You might need to remove the system cabinet
doors to improve airflow through the system cabinet.
For thermal rating information refer to the rack or system cabinet manuals provided
by the manufacturer.
You must use only the screws that are provided in the kit.
If you are lifting and moving the unit by hand, attach the four handles. Push up on each
handle until it clicks into place.
2
Place the back of the unit (the end with the connectors) on the rails.
Caution: An empty unit weighs approximately 60 kg (132 lbs). Four persons are required
to safely move an empty unit. A fully loaded unit weighs approximately 113 kg (250 lbs). A
mechanical lift is required to safely move the unit.
Supporting the unit from the bottom, slide the unit into the cabinet. If you are using the
handles, use the thumb latches to detach the handles as you slide the unit in.
1
Installation manual
DSA E-Series (E2800 60-bay)
Bosch Security Systems B.V.