Removing A Power Canister; Installing A Power Canister; After Replacing A Power Canister - Bosch DSA E‑Series Installation Manual

42 en | Maintenance
3.
Refer to
–
8.2.2

Removing a power canister

To remove a power canister:
1.
2.
3.
4.
5.
6.
8.2.3

Installing a power canister

To install a power canister:
1.
2.
3.
4.
5.
8.2.4

After replacing a power canister

After replacing a power canister, you must confirm that the new power canister is working
correctly. Then, you can gather support data and resume operations.
To confirm that the new power canister is working correctly:
1.
2.
3.
2020-05 | V2 | DOC
From the back of the storage array, look at the Attention LEDs to locate the power
canister you need to remove. You must replace the power canister that has its Attention
LED on.
LEDs on the power canister, page 18
Put on antistatic protection.
Unpack the new power canister and place it on a level surface near the unit.
Save all packing materials for use when returning the failed power canister.
Turn off the power switch on the power canister that you need to remove.
Open the power cord retainer of the power canister that you need to remove, then unplug
the power cord from the power canister.
Press the orange latch on the power canister cam handle, then open the cam handle to
fully release the power canister from the mid plane.
Use the cam handle to slide the power canister out of the unit.
Note: When removing a power canister, always use two hands to support its weight.
Make sure that the on/off switch of the new power canister is in the Off position.
Using both hands, support and align the edges of the power canister with the opening in
the system chassis, then gently push the power canister into the chassis using the cam
handle until it locks into place.
Note: Do not use excessive force when sliding the power canister into the chassis; you
can damage the connector.
Close the cam handle so that the latch clicks into the locked position and the power
canister is fully seated.
Reconnect the power cord to the power canister, and secure the power cord to the
power canister using the power cord retainer.
Turn on the power to the new power canister.
Check the green Power LED and the amber Attention LED on the new power canister.
The Power LED must be on and the Attention LED must be off (see LEDs on the power
canister, page 18 ).
From the Recovery Guru in SANtricity System Manager, select Recheck to ensure the
problem has been resolved.
If a failed power canister is still being reported, repeat the steps in Removing a power
canister, page 42 and Installing a power canister, page 42 . If the problem continues to
persist, contact technical support.
Installation manual
DSA E-Series (E2800 60-bay)
Bosch Security Systems B.V.