Installing Superrail To Round-Hole Four-Post Rack - Bosch DSA E‑Series Installation Manual

DSA E-Series (E2800 60-bay)
5.
6.
7.
4.2.2

Installing SuperRail to round-hole four-post rack

When installing SuperRail on a standard round-hole four-post rack you must use the 4 round-
to-square hole adapter brackets.
Scope of delivery: SuperRail for round-hole four-post rack
(M4x15) x 4
To install SuperRail to round-hole four-post rack:
1.
Bosch Security Systems B.V.
For both front rail posts: Secure the unit to the front of the rack or system cabinet and
rails by inserting the screws through the holes of the unit, the holes on the rack or system
cabinet, and the holes on the front of rails.
M10x32
For both rear rail posts: Secure the unit to the rear of the rack or system cabinet and rails
by inserting the screws through the hole of the unit, the hole on the rack or system
cabinet, and the hole on the front of rails.
M10x32
If applicable, replace the end caps or the system bezel.
(M4x10) x 8
Determine where you want to install the unit in the rack or system cabinet.
Note: Whenever possible, install the units from the bottom of the rack up, so that you can
use the units underneath as a guide for installing the next set of rails.
Rails x 2
Installation manual
Installation | en 23
x 4
2020-05 | V2 | DOC