Table of Contents
Advertisement
DOK-INDRV*-KMS02******-IT01-EN-P
Rexroth IndraDrive Mi Distributed Drive Controller KMS02
5
Instructions for Use
5.1
Mounting
5.1.1
Required Steps to Follow
Preparations
Mounting KMS
Mounting for Easy Servicing
Notes on Mounting
5.2
Installation
5.2.1
General Information on How to Install the Drive Controller
Make the following preparations for mounting:
1. Procure tools, auxiliary materials, measuring and test equipment.
2. Check all components for visible damage. Defective components
mustn't be mounted.
3. Ensure that dimensions and tolerances on the installation side are suita‐
ble for attachment (for details, see dimensional drawing).
4. Check whether all components, mounting surfaces and threads are
clean.
5. Ensure that mounting can be done in a dry and dust-free environment.
To allow trouble-free servicing, make sure that the following aspects are fulfil‐
led after you have mounted KSM:
●
Connection points X37, X38 and X141 are easily accessible
●
Connection points X108 and X109 are easily accessible
●
Address selector switches are easily accessible
●
Diagnostic LED H14 is visible
1. Preferably mount KMS to a conductive surface. If this is impossible, lat‐
er on connect the second connection point of equipment grounding con‐
ductor at KMS to the equipment grounding system of the installation.
2. For the dimensions of the mounting holes, see the Dimensional Drawing
KMS.
3. Data of the mounting screws:
●
Thread: M6
●
Head diameter: < 11 mm
●
Tightening torque: 6 Nm
WARNING
Before working on live parts: De-energize installation and secure power
switch against unintentional or unauthorized re-energization.
Wait at least 30 minutes after switching off the supply voltages to allow dis‐
charging.
Check whether voltage has fallen below 50 V before touching live parts!
Bosch Rexroth AG
Lethal electric shock by live parts with more
than 50 V!
31/73
Instructions for Use
Advertisement
Table of Contents
