Power Button - Inkbird ITC-306A Manual

Back to Front Page
Temperature Unit Switch
Temperature Calibration
High Temperature Value
Low Temperature Value
Continuous Heating Time
06
Controlling Function Description
6.1 Button Description
6.1.1 Restore to Factory Settings
Press and hold the decrease button
once, that all parameters will restore to the factory settings.

6.1.2 Power Button

In any case, press and hold
output. After power off, short press to turn on the power. In the power on
state, short press to turn on or pause the socket power. In the paused state,
PV displays the current temperature, SV displays "P", there will be no output.
6.1.3 Quickly Set the Control Temperature Mode
Tap "SET"button to enter the quick setting control temperature mode, SV
displays the temperature setting value1 and flashes. At this time, press
or to increase or decrease the setting value. Long press and hold the
POWER
or button to increase or decrease the setting value quickly. Then press
POWER
again SET button, SV displays the temperature setting value2 and flashing,
At this time, press
press and hold the
quickly, press SET button again to confirm and exit. If there is no operation,
it will automatically exit after 10 seconds and save the set value.
6.1.4 Button Function in Setting Mode
When the controller is working normally, press and hold the SET button for 2
seconds to enter the setting mode. PV displays the code"TS1", and SV
displays the corresponding setting value. Press the SET button to scroll down
the menu and save the parameters of the previous menu item, or press the
or button to change the current setting value. If there is no button
POWER
WIFI
operation within 30 seconds or long press the SET button for 2 seconds in
for 2 seconds to turn off, there will be no
POWER
or to increase or decrease the setting value. Long
WIFI POWER
or button to increase or decrease the setting value
WIFI POWER
to power on, the buzzer will beep
POWER
WIFI
WIFI