Mounting The Converter - Samson System 6000 Mounting And Operating Instructions

Installation

5.3 Mounting the converter

The converter can be mounted to a wall, a
pipe (Ø 2") or directly to a control valve (see
Fig. 5-1).
Wall mounting
The converter is delivered with a stainless
steel bracket for wall mounting (order no.
1400-7432).
Î Fasten the mounting bracket to the back
of the converter using two screws.
Î Fasten the mounting bracket to the wall
using four screws (see Fig. 5-1 for drill
pattern).
Pipe mounting (Ø 2")
− Required accessories:
Pipe mounting (order no. 1400-6216)
Î Unfasten the clamp from the mounting
bracket.
Î Fasten the mounting bracket to the back
of the converter using two screws.
Î Place the clamp around the pipe. Hold it
in position and fasten it to the mounting
bracket.
Mounting on the valve yoke
− Required accessories:
Mounting on cast yoke according to
NAMUR (order no. 1400-6217)
Î Fasten the adapter block to the back of
the converter using two screws.
Î Screw the adapter block into yoke bore-
holes on the valve yoke.
5-2
Attachment to valves with rod-type yokes
− Required accessories:
Mounting on rod-type yoke according to
NAMUR (order no. 1400-6218)
Î Unfasten the clamp from the mounting
bracket.
Î Fasten the mounting bracket to the back
of the converter using two screws.
Î Place the clamp around the stem of the
control valve. Hold it in position and fas-
ten it to the mounting bracket.
EB 6126 EN