Notes On Possible Personal Injury - Samson System 6000 Mounting And Operating Instructions

Referenced standards and regulations
The electropneumatic converters comply with the requirements of the Directives 2014/30/EU
and 2011/65/EU. Converters with a CE marking have a declaration of conformity, which
includes information about the applied conformity assessment procedure. This declaration of
conformity is included in the 'Certificates' section.
Referenced documentation
The following documents apply in addition to these mounting and operating instructions:
− Mounting and operating instructions of the downstream pneumatic controller
− Mounting and operating instructions of the downstream pneumatic control valve (valve,
actuator and valve accessories)
− Mounting and operating instructions of the upstream electric measuring equipment

1.1 Notes on possible personal injury

WARNING
!
Damage to health relating to the REACH regulation.
If a SAMSON device contains a substance which is listed as being a substance of very
high concern on the candidate list of the REACH regulation, this circumstance is indi-
cated on the SAMSON delivery note.
Î Information on safe use of the part affected: go to u www.samsongroup.com >
About SAMSON > Material Compliance > REACH.
Risk of personal injury through incorrect operation, use or installation as a result of
information on the device being illegible.
Over time, markings, labels and nameplates on the device may become covered with
dirt or become illegible in some other way. As a result, hazards may go unnoticed and
the necessary instructions not followed. There is a risk of personal injury.
Î Keep all relevant markings and inscriptions on the device in a constantly legible
state.
Î Immediately renew damaged, missing or incorrect nameplates or labels.
EB 6126 EN
Safety instructions and measures
1-3