11 Decommissioning
The work described in this section is only to
be performed by personnel qualified for the
assignment accordingly.
Supply air
Î Close and lock the supply air line.
Electrical connections
Î Disconnect the electrical supply and pro-
tect it against unintentional reconnection.
Î Unscrew the fastening screw (1) of the
plug connector and pull the plug insert
(3) out of the plug base at the housing.
1
Fastening screw
2
Plug connector case
3
Insert
4
Recess
5
Rubber seal
6
Cable gland
Fig. 11-1: T erminal assignment at the plug connector
EB 6126 EN
5
4
1 (+)
nur bei 0 (2)...10 V
4 (0)...20 mA
0 (2)...10 V
Î Pull the fastening screw out of the plug
connector and remove the rubber seal
(5).
Î Place a screwdriver at the recess (4) and
lever the plug insert (3) out of the plug
connector case.
Î Disconnect lines for the input signal from
the terminals 1(+) and 2(–).
–
Additionally, disconnect the voltage
supply at terminal 3 in u/p
converters.
Î Push the insert into the connector housing
(2) and push on the rubber seal (5).
3
2 (–)
3 (+)
24 V DC
Decommissioning
2
1
6
11-1