ST16S Inspection
ST16S Front & Bottom
Cooling Fan Lift the sticker
covering the bearing to
lubricate.
ST16S Top & Back
The two HEX screws circled in red are for
adjusting tension on the joystick in its two
directions of movement. ENSURE the
plastic block the screw is attached to is not
binding when you adjust so you
strip the screw or plastic block threads.
If you wish to lubricate with a grease or
Teflon spray make sure you
DO NOT
OVER DO
IT. Areas in GREEN
The Phillip's screws are over the pivot
points – and are for removing the
gimbals out of the mount/frame.
Do NOT
22