Proper Tool; Tools Needed For Basic Maintenance; Note On Silicone Spray Use - YUNEEC Typhoon H Plus Maintenance, Troubleshooting & Parts

Tools needed for Basic Maintenance:

#00 size Phillips screwdriver
#0 size Phillips screwdriver
JIS screwdriver #00
#1 size Phillips screwdriver
1.5mm Hex Driver [4in (102mm) shaft length]
2.0mm Hex Driver [4in (102mm) shaft length]
2.5mm Hex Driver [4in (102mm) shaft length]
Small pair of tweezers or hemostats
Bottle for bearing lubricant w/needle applicator or a syringe
Electronic contact cleaning spray – SAFE for plastic
Tube of extra-fine graphite lubricant (dry)
Silicone or Teflon spray lubricant
A quality Grease or Vaseline
Small tube of RTV silicone caulk
Flashlight
Magnifying glass
Microfiber lens cleaning cloth
Lint free cleaning cloth
Cotton swabs
Can of compressed air
Small Vacuum cleaner
Small medium bristle brush
Small Soft bristle brush
Spanner wrench for toggle switch nut
Lock tight (thread lock) for small screws
Because silicone spray is super slippery and minimally-reactive, it can lubricate almost anything. It works especially well on porous
items, such as plastic parts. Because silicone spray is water resistant, it can also protect items from moisture.
Silicone has its dark side:
The fact that it is a spray allows you to put it in places that greases cannot be applied, such as into mechanisms
(locks, clocks, etc.), bearings or electrical contact points (switches, rotatory controls).
DO NOT use silicone spray on electrical connections, switches, relays etc. Because it can act as an insulator.
– a little is all that is needed, remember you will want to get it off at some point without stripping the screw/bolt or
Lock tight (thread lock)
damaging your equipment. More is NOT better.
PROPER TOOL FOR A PROPER JOB
NOTE
on silicone spray use
4