Yuneec Typhoon Arm -- Spring Clip Replacement; Introduction; You Will Need A Thin Flat Item To Lift The Tab Above A Dent; Using A Jis 00 Screwdriver, Unscrew The 3Mm Screw - YUNEEC Typhoon H Plus Maintenance, Troubleshooting & Parts

Introduction

The Arm Latch for the Yuneec Typhoon H+ Plus is the component essential to keeping the arm locked in the upward position. The Typhoon H+
Plus Arm Latch is located at the top of the arm under the word "press". It is a replaceable component that can be installed or uninstalled with
relative ease. To replace the Arm Latch simply remove the screw that holds it in place.
This guide provides directions on how to replace the spring clip (i.e. arm clip) on the arm attachment.
Tools
Tweezers
JIS #00 Screwdriver
Parts
1 YUNTYH123SVC Spring Clip.

You will need a thin flat item to lift the tab above a dent.

Yuneec Typhoon Arm -- Spring Clip Replacement

Using a JIS #00 screwdriver, unscrew the 3mm screw.
If the screw is hard to remove once fully unscrewed, to remove the screw
flip the drone upside down and have the screw fall out.
For this step the arm must be lowered.
Remove the broken arm clip by pinching the metal top with a Tweezers
and then pull it out in an upward direction.
Reverse steps to complete replacement.
26