Table of Contents
Advertisement
5. Prime the pump by removing the plug on the top of the pump and filling it with oil. Wait
until the oil levels equalize between the reservoir and the pump, then replace the plug
and making sure the seal is tight.
6. Attach nose piece to ram by inserting shank into ram and tightening the set screw.
MOVING THE TABLE
CAUTION!
1. Place the hoist crank on the lift drum shaft. Turn the hoist crank to relieve the pressure on
the table pins. Keeping tension on the hoist crank, remove the table pins on at a time.
After removing the table pins, turn the crank that controls the table and run it top to
bottom.
2. Ensure that the cable is tracking correctly, this means the cable should be on each of the
two upper pulleys and should track back and forth on the cable drum.
a. If tracking problems exist, contact the Dake for instructions.
3. Be sure the table pins are fully inserted in place before applying pressure, servicing,
cable tracking, or set up for desired work opening.
the cable before operating the press.
905050
Always be sure to put slack into
9
Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
www.dakecorp.com
REV112019
Advertisement
Table of Contents
