Kioti DS4110 Manual page 84

(1) Hand Throttle lever
"Fast" "Slow"
7. Set the hand throttle lever to the
"Slow" position. (In case of cold
weather you may adjust it to "Fast"
for easier starting)
8. depress the clutch pedal.
(It cannot be started while the
clutch is not depressed)
M50-EU-05.indd 5
H61O504A
(1) key Switch
(B) Acc
(d) pre-heat
9. Insert the key into the key switch
and turn it "oN" and maintain it
until the preheat lamp is turned off
(approx. 8 sec.) in case the auto
pre-heating kit is equipped.
In case of the basic model, hold
the key in "d" (pre-heat) posi-
tion for several seconds for manu-
al pre-heat. during the same sec-
onds, the pre-heat lamp on the
dash board illuminates.
It is normal that the charge warn-
ing lamp and engine oil pressure
warning lamps come on when the
key is in "oN" position before the
engine start.
operating principle of auto pre-
heating system (If equipped)
The glow plug lamp comes on

for 8 seconds and then goes off
H61O403A
when the key switch is turned to
the "Start" or "Stop" position.
(A) Stop
The engine should be started
(C) on
within 5 seconds after the glow
(E) Start
plug lamp goes off. After the en-
gine is started, post-heat is per-
formed for 15 seconds with the
key switch in the "oN" position.
The post-heating is a function

to keep the glow plugs activat-
ed for approx. 15 seconds af-
ter the engine is started in order
to enhance the engine combus-
tion performance and to reduce
harmful emissions right after en-
gine start.
5 5
opERATIoN opERATIoN 5 5
- -
NOTE
5
2009-09-28 오후 6:13:17