Kioti DS4110 Manual page 149

7
-0 Ds4110(hs) / Ds4510(hs)
(1) radiator cap (2) reservoir Tank
(a) Full (B) low
6. install the radiator cap securely.
7. start and operate the engine for
few minutes.
8. stop the engine and let it cool.
9. Drain water and cooling system
cleaner and close drain cock,
and fill with antifreeze and water
mixture and close radiator cap
securely.
10. run tractor at idle until up to op-
erating temperature.
M50-EU-07.indd 30
11. check coolant level of reservoir
tank and radiator. add coolant if
necessary.
Coolant capacity
CAUTION
To avoid accidents:
Do not remove the radiator cap

while the coolant is hot. you
H61O738A
can get burnt by hot steam.
Make sure to remove it after
the coolant is cooled down
enough.
Even though the coolant is

cooled down, turn the cap to
its first stop and then wait until
it is depressurized before re-
moving the cap completely.
Do not start engine without

coolant.
Use clean, fresh water and an-

8.9 L (2.4 u.s. gal.)
ti-freeze to fill the radiator and
reservoir tank.
When the anti-freeze is mixed

with water, the anti-freeze mix-
ing ratio must be no less than
50% mixture of water and anti-
freeze.
Securely tighten radiator cap.

If the cap is loose or improp-
erly fitted, water may leak out
and the engine could overheat.
If the radiator cap has to be

removed, follow the caution
above and securely retighten
the cap.
If the coolant leaks, contact

your local KIOTI Dealer.
IMPORTANT
2009-09-28 오후 6:11:48