Table of Contents
Advertisement
Display "MIXER"
14 / 20
With this RSSI signal and a
48377, the signal strength of the receiver can be displayed in video
goggles or monitors.
Adjustment range: OFF, CH8, CH12, CH16
F.RESET
A er changing the value
on the ENT key, or equivalent, a factory reset of the receiver is per-
formed.
Up t
ve mixers can be programmed in the receiver.
MIXER
In the "MIXER" line, select one of mixers 1 ... 5.
The following se
in this display only relate to the mixers selected
in the "MIXER" line.
MASTER CH
In this line the MASTER CH (signal source or source channel) has to
be selected.
range: (CH)1 ... (CH)6
If no mixer has to be set, select "0".
AVE CH
In this line, select the SLAVE CH (signal source or source channel) to
which the signal of the MASTER CH (source channel) is pr
ally mixed.
The level of mixing is determined by the percentages entered in the
"TRAVEL–" and "TRAVEL+" lines.
range: (CH)1 ... (CH)6
If no mixer has to be set, select "0".
TRIM
Analogous to the trimming of the control
tral
of the mixer in the range of ± 30% can be trimmed in
this line.
TRA
With the se
of these two lines, the percentage of mixing is
in rela
to the MASTER signal separately for both direc-
ht control board with OSD, e.g. No.
to "Yes" and then pressing or tapping
1 ... 4, the neu-
-
S1012_GR-12L_DE_V1sh
- Quick Links:
- Firmware Update
Hide quick links:
Advertisement
Table of Contents
