Receiver Reset - GRAUPNER GR-12L Manual

Receiver reset

S1012_GR-12L_DE_V1sh
If the red LED of the GR-12L HoTT lights up again constantly, the
"Binding" has failed. Change the
antennas and try the en
To reset the receiver, press and hold its SET bu on while turning on
the power to the receiver:
If the reset was triggered with the transmi er switched o or with
an unbound receiver, the red LED of the receiver GR-12L HoTT starts
t a er about 3 seconds. The bu on will now be released.
If the reset is performed with a not bound receiver, you can then
start a binding process at an
If a reset has already been performed on an already-bound receiver
and the associated model memory is
mi er, then the red LED of the receiver GR-12L HoTT should go out
and thus signal a correct c
the process has to be repeated.
Notes
Through a RESET
to the factory se
niza nforma
If a reset is performed accidentally, all of these se
were made using the "Telemetry" menu in the receiver should
be restored.
Rese is
switch a receiver to a di erent model. This makes it easy to keep
se
cedure again.
ve in the switched-on trans-
to the transmi er. Otherwise
of the se in the receiver are brought
with the excep of the HoTT synchro-
recommendable when you want to
atch from being transferred.
of the associated
that
11 / 20