Komatsu WA320-5H Operation & Maintenance Manual page 4

FOREWORD
EU DIRECTIVES
Machines supplied by us fulfil the Directive for Machinery 89/392/EEC and all supplements. If the machine is being
used in another country, it is possible that certain safety regulations and specifications may not be fulfilled for use
in that country. For example, priority vehicle warning lamps may be used in some countries, but are forbidden in
others.
Please contact our dealer before using the machine if you have any questions regarding the fulfilment of standards
and regulations in a specific country.
Notes on subsequent installation of electrical and electronic equipment and components
Electrical and electronic equipment and/or components which have been installed subsequently, emit electromag-
netic radiation which can influence the function of the electronic components and sections of the machine. This
can have an influence on the safety of the machine and endanger persons. For this reason, please ensure that the
following safety instructions are observed.
If you are installing electrical or electronic equipment and/or components in the machine and connect them to the
vehicle electrical system, you must check at own responsibility that the installations do not cause any disturbance
to the vehicle's electronic system or other components. Above all, you must ensure that any subsequently installed
electrical and electronic components comply with the EMV Directive 89/336/EEC in its current edition and bear the
CE mark.
The following requirements also have to be met for subsequent installation of mobile communication systems (e.g.
q Only equipment approved by national legislation (e.g. BZT approval for Germany) may be used
radio, telephone):
q The unit must be fixed in position
q Portable or mobile units may only be used inside the vehicles if they are connected to a fixed outside
antenna
q The transmitter unit must be spatially separated from the vehicle's electronic system
q Make sure when installing the antenna that this is installed correctly with good earth connection between
antenna and vehicle mass
Also observe Komatsu and manufacturer's installation instructions for wiring, installation and maximum permitted
power consumption.
0.
FOREWORD
1-3