Komatsu WA320-5H Operation & Maintenance Manual page 281

MACHINE MONITOR WITH LOAD METER
4. If the display is "ADDITION MODE", press the (>) or (<) of
monitor panel mode selector switch 2 to display "REMAIN
MODE".
5. Press the ( ) of monitor panel selector switch 1 and dis-
play "MATERIAL < > SELECT".
6. Check the display for the selected material on load meter
display (1).
The present selection display is B.
In the remain mode, "REMAINING TARGET" is displayed
on display (2).
7. If B is to remain selected, press the ( ) of monitor panel
mode selector switch 1. B is then selected.
If B is to be changed to A, C, D or E, press the (>) or (<) of
monitor panel mode selector switch 2 to select the type of
material, then press the ( ) of monitor panel mode selector
switch 1.
8. Press the ( ) of monitor panel selector switch 1 and dis-
play "INPUT TARGET".
9. Input the target load.
Before the target is input, "0000.0 t" is displayed on the tar-
get line and the cursor is at the 1000 ton position.
The following explanation explains the procedure when inputting 30 tons as the target.
10. "0" is marked by the cursor at the 1000 ton position, so leave it at "0" and press the ( ) of monitor panel selec-
tor switch 1.
"0" is selected and the cursor moves to the 100 ton position.
11. "0" is marked by the cursor at the 100 ton position, so leave it at "0" and press the ( ) of monitor panel selec-
tor switch 1.
"0" is selected and the cursor moves to the 10 ton position.
6-34
ATTACHMENTS, OPTIONS