Error Messages, Beeps And Flashes - Fireco Dorgard X2 Fitting And Operating Manual

Error Messages, Beeps and Flashes

Beep/Flash Sequence
During Power up
LoHi-LoHi-LoHi
Long lo (followed by) short Hi
O ---------------------------------
*
Lo-Lo-Lo-Hi
During standard operation
* *
---(32secs)--- ---(32secs)---
HiLo – HiLo – HiLo – HiLo – HiLo – HiLo – HiLo – HiLo
O ------- O ------- O ------- O ------- O ------- O ------- O ------- O
LoHi – LoHi – LoHi – LoHi – LoHi – LoHi – LoHi – LoHi
O ------- O ------- O ------- O ------- O ------- O ------- O ------- O
– LoHi – LoHi –
----- O ------- O
LoLoLoHi
*
........
Tone and flash sequence is followed by the sound.
*** ***
---(5secs)--- ---(5secs)---
This continues for 5 minutes after release.
Lo (long tone)---Hi
O (long flash)
(long flash) ------- every 2 seconds.
* *
Key: * LED flash GREEN
O LED flash RED
* *
---(32secs)--- ---etc.
***
---(5secs)---
23
What it means?
Indicates Battery Lift is
open during power up.
Indicates start of power up
test.
Power up test complete.
LED indicates that the
system is working properly.
2
Dorgard X is about to
release its door.
2
Dorgard X has released its
door.
2
Dorgard X resetting ready
for re-activation.
Range Test release
command received.
2
Link Button on Dorgard X
has been pressed.
Association with System X
has been deleted.
2
Dorgard X is in Link mode.
Remedy
No action required.
No action required.
No action required.
No action required.
No action required.
No action required.
No action required.
No action required.
No action required.
LED will flash until Linked
with a System X transmitter,
but will time out after 5
minutes.