Linking Dorgard X - Fireco Dorgard X2 Fitting And Operating Manual

Linking Dorgard X

2
1. Ensure installed System X is not in an error state and the
CIE is not in a fire or fault state.
2. Ensure the Batteries are installed into the Dorgard X
3. On System X press and hold Button 1 LINK until the LCD
reads 'LINK'. System X is now accepting Link data to the
2
Dorgard X unit.
4. Using the supplied plastic Screwdriver gently press the
Link Button on the front of the Dorgard X
Button down until the LED located on top of the Dorgard
2
X unit lights red and the Dorgard X
This resets the Dorgard X
other System X transmitters.
5. After the motor of the Dorgard X
beep has stopped, hold the Link Button on the front of the
2
Dorgard X down again until the LED located on top of the
2
Dorgard X unit lights green. The Dorgard X
searching for a TX to Link to.
6. When Dorgard X
transmitter its motor will drive, allowing the Plunger to be
held down. System X's LCD will also display the Dorgard
2
X 's Location Code, its signal strength, battery level and
software version. The Dorgard X
noted in the Installation Log at the rear of this Guide and
on the supplied sticker which should be attached to the
top of the Dorgard X
Note: the first Linked unit will be given the Location
code 000, the second Linked unit will be Location
code 001 etc.
7. If more Dorgard X
once powered up, press the Link Button on the front of the
2
Dorgard X one at a time, waiting for confirmation on the
System X LCD between units.
8. When finished, press Button 1 LINK on the System X to
return to displaying the Clock.
Note. A maximum of 200 Dorgard X
linked to any one System X transmitter.
9
2
beeps a long tone.
2
and erases all associations with
2
has driven and the reset
2
has successfully Linked to the System X
2
Location code should be
2
and in this User Guide.
2
units are to be added to the system,
2
2
unit.
2
unit. Hold this
2
is now
units can be