Installing The Device - Siemens RUGGEDCOM RSG2100 Installation Manual

Installing the Device

The following sections describe how to install the device, including mounting the de-
vice, installing/removing modules, connecting power, and connecting the device to
the network.
Electrocution hazard – risk of serious personal injury and/or damage to equip-
ment.
Before performing any maintenance tasks, make sure all power to the device has
been disconnected and wait approximately two minutes for any remaining energy
to dissipate.
Do not disconnect or open equipment unless power has been switched off or the
area is known to be non-hazardous.
Débrancher ou ouvrir l'équipment seulement si l'alimnetation a été coupée ou si l'on
sait que la zone ne pose aucun danger.
Substitution of the components may impair suitability for Class I, Division 2.
Le remplacement de composants pourrait compromettre l'admissibilité à la Classe I,
Division 2.
Radiation hazard – risk of serious personal injury
This product contains a laser system and is classified as a CLASS 1 LASER PRODUCT.
Use of controls or adjustments or performance of procedures other than those speci-
fied herein may result in hazardous radiation exposure.
NOTICE
This product contains no user-serviceable parts. Attempted service by unauthorized
personnel shall render all warranties null and void.
RUGGEDCOM RSG2100
Installation Manual, 03/2020, C79000-G8976-1040-17
DANGER
WARNING
AVERTISSEMENT
WARNING
AVERTISSEMENT
WARNING
2
7