powersoft IpalMod Service Manual page 23

13. Initialization Procedure (restore to Factory Presets)
Set up the working area in the same manner described in the FirmWare Update Procedure.
The factory preset is available in: restricted area - service amp modules - ipalmod tools
Switch the IpalMod On.
Launch the PowerControl Manager (v 2.3.15 onward)
Launching the PowerControl Manager
Click on the module
Select the "PRIPAL02-IPALDSP PRESET Rev.01 del 28-092015.pow"
File (or any of its latest releases available on the restriced area)
The procedure will be over once the "loading preset" pop up disappears.
1
Verify that the RED LED on the RS485 is blinking
3
5
IPALMOD | SERVICE MANUAL
Click on "Find Amplifiers"
Click on "Load"
Click on the EQ Window
2
4
6
23