Table of Contents
Advertisement
Figure 2.
Actuator cover assembly
Figure 4.
Actuator mounting
Mounting the Actuator Control Panel
Only one control panel is required for single or dual circuit units.
Refer to
Table 1, p. 5
to determine if a control panel is required.
The actuator control panel may be mounted on the back of the
main unit control panel, condenser coil sheetmetal blockoff,
condenser bulkhead, or on special mounting bracket;
depending on unit type and size. Refer to
Figure 6, p. 10
for the mounting location for the unit being
converted. Use the following steps to mount the actuator
control panel.
ACC-SVN137C-EN
Hazardous Voltage!
Failure to disconnect power before servicing could
result in death or serious injury.
Disconnect all electric power, including remote
Figure 5, p. 10
and
disconnects before servicing. Follow proper lockout/
tagout procedures to ensure the power can not be
inadvertently energized. Verify that no power is present
with a voltmeter.
1. Remove the appropriate panels to allow access to the
Figure 3.
Actuator cover assembly
WARNING
actuator control panel installation location.
Installation
9
Advertisement
Table of Contents
