Rinnai RUC80i Training Program page 83

Setting Manifold Gas Pressures
Upon installation of the water heater, dip switches on the PCB must be set for the correct
altitude and vent length. If gas pressure checks or adjustments are made at a later date
(due to parts changes, conversions etc.) ensure the dip switches are set correctly for your
water heater model, gas type, altitude and vent length then refer to the corresponding
gas pressure chart for the proper gas pressure settings.
© 2016 Rinnai America Corporation
PROPRIETARY and CONFIDENTIAL
Enhancing Lives By Changing The Way Water Is Heated
:
83 5/4/2018