Error Message 922; Error Message 941 - Digital Networks DECserver 708 Installation Manual

Error Message 922

Local –922– Port hardware error on port n
Problem
The specified port has failed self-test.
Correction
There is no corrective procedure for this condition. Notify the network manager that
the DECserver 708 must be returned to Digital Networks for repair or for replacement.
Refer to the Network Access Server Problem Solving manual for information about
returning the unit to Digital Networks.

Error Message 941

Local –941– Transceiver loopback error
Problem
The Ethernet port has failed self-test.
Correction
•
Standard Ethernet/ ThinWire Ethernet – Disconnect the cables or MAU from the
standard Ethernet connector and insert a loopback connector part number 12-
22196-02. Test the hardware again by pulling out the power cord and reinserting
it. If this corrects the problem, the fault is external to the DECserver 708. If this
fails to correct the problem, notify the network manager that the DECserver 708
must be returned to Digital Networks for repair or for replacement. Refer to the
Network Access Server Problem Solving manual for information about returning
the unit to Digital Networks. If the DECserver 708 passes self-test, then the
problem lies in the cables or equipment connected to the DECserver 708.
•
10BaseT Ethernet – 10BaseT Ethernet cannot be checked by using a loopback
connector on the DECserver 708. Replace the cables and device that is connected
to the DECserver 708. If this corrects the problem, the fault is external to the
DECserver 708. If this fails to correct the problem, notify the network manager
that the DECserver 708 must be returned to Digital Networks for repair or for
replacement. Refer to the Network Access Server Problem Solving manual for
information about returning the unit to Digital Networks. If the DECserver 708
passes self-test, then the problem lies in the cables or equipment connectedto the
DECserver 708.
System OK LED Flashing
What to Do If You Have Problems 6-9