Installation And Setup - LEGRAND radiant WWRL10WHCCV2 Manual

installation & setup
1 | turn off power to device at circuit breaker
Flip existing light switch multiple times to confirm power is off.
NOTE: Ensure power is off to all devices in electrical box.
1
2 | remove existing device
Check for the following wires:
HOT or LINE: Receives power from the circuit box. Referred to as "hot" for
a
the purposes of this guide. Do not touch or let "hot" wires contact other wires.
LOAD: Directs power to your light(s).
b
NEUTRAL: Creates a path to return current to the power source when the
c
device is off. Required for your switch installation.
GROUND: Provides a safe path for electricity in the event of a short circuit.
d
TRAVELER: If more than one switch controls the light, an additional wire
e
will be in the box that "travels" to the other switch.
2
Load
Supply
"Hot"