Advertisement
Installation
Positioning the sensor
1 m
2,5 m
≥ 2,5 m
Settings
Sensor parameters
Time delay
Sensitivity
Brightness threshold
Auto
Walkthrough
Eco
Initial
Holding
Retrigger
Alarm
Calibration
Adjustment
Contribution of light
Time delay
The period of time after which the load is switched o if no movement is detected.
The time restarts whenever the sensor detects a movement.
Sensitivity
Adjustment of the sensitivity of the detection technology used.
Brightness threshold
Lighting level below which the sensor activates the load and above which it
switches it o .
Default value
15 mn
PIR (very high) / US (high)
300 lux
Not active
ON
Not active
PIR and US
PIR or US
PIR or US
Not active
−
Not active
Automatic
574048
574098 AM5658
PIR
US
Adjustable parameters
3,5,10,15,20 min
30s - 255 h 59 min 59s
Low, medium, high, very high
20, 100, 300, 500, 1000 lux
0 - 1275 lux
ON/OFF
ON/OFF
ON/OFF
PIR and/or US, PIR, US
PIR and/or US, PIR, US
PIR and/or US, PIR, US, OFF
ON/OFF
0 - 99995 lux
ON/OFF
Automatic - 1275 lux
Operating mode:
Auto
The load is automatically switched on:
- upon detection of a movement if the level of natural light is insu cient.
The load is automatically switched o :
- if no movement is detected at the end of the set time delay + standby time.
- or if the level of natural light is insu cient (adjustment on).
Each new detection causes automatic switching on if the light is insu cient.
Walkthrough
067226 HD/HC/HS4658
L/N/NT4658N
Position the sensor so
that it is not a ected by
the arti cial light already
present in the room.
Con guration remote control
88230
88235
BMSO4001
BMSO4003
−
−
−
−
−
−
−
−
−
−
−
Advertisement
