Emerson Rosemount MCL-220 Reference Manual page 19

Reference Manual
00809-0100-3414
Figure 4-2: Alarm relay connections
A. Alarm relay 1
B. Alarm relay 2
C. Alarm relay 3
D. Alarm relay 4
1. To remove the cover, grab it by the upper edges and pull straight out. The relay
2. Bring the relay wires through the rear conduit opening on the left hand side of the
3. Replace the cover. The two tabs on the back edge of the cover fit into slots at the
Keep alarm relay wiring separate from signal wiring. Do not run signal and power or relay
wiring in the same conduit or close together in a cable tray.
Rosemount MCL
terminal strip is at the top of the board.
enclosure and make connections to the terminals strip.
rear of the enclosure, and the three small slots in the front of the cover snap into the
three tabs next to the relay terminal strip. See
up, push the cover to snap it in place.
Figure 4-2. Once the tabs are lined
Wire
May 2019
19