Power-Up; Battery; Battery Charge - SEFRAM 7849B User Manual

3 Power-up

All the material is checked before shipment and delivered in an adapted packaging.
There is no particular unpacking instruction.
The appliance is equipped with a Lithium-Ion (Li-ion) battery. It is shipped with the battery loaded.
However, if the appliance has remained idle more than one month long, check its charge state and reload
if required.
The device has a capacitive touch slab.
Use with gloves is not possible.
In order not to damage your screen, do not use a stylus or object.
3.1

Battery

Attention: Any intervention on the battery requires the disassembly of the appliance and
should be made by a SEFRAM technician.
Use only batteries provided by SEFRAM.
Security advice:
 Do not throw into the fire or heat up the battery pack
 Do not shunt the parts of the battery: risk of explosion!
 Do not drill
 Do not disassemble the battery pack
 Do not reverse the polarities of the battery
 This battery pack includes a protective item that should not be damaged or removed
 Protect the pack from the heat while storing
 Do not damage the protective sheath of the pack
 Do not store the appliance in a vehicle under sunlight
 Used batteries are not for domestic waste; lithium batteries should be recycled.
The battery has a 200-charge-discharge cycle life or 2 years.
Advice to extend the life of your battery:
 Avoid deep discharges
 Do not store the batteries too long without using them
 Store the battery around 40% loading
 Do not fully charge or fully discharge the battery before storage.
When the battery is almost fully discharged, the appliance will warn "Low battery", and then will shut
off after a few minutes.
3.2

Battery charge

To charge the battery inside the appliance:

Connect the external power supply provided through the jack plug of the appliance (above)
7849B – 7859B – 7817B
p.
13