Advertisement
the tool can match the power supply, otherwise the power tool may be damaged and cause injuries.
Don't wipe plastic part with solvent: Solvent such as gasoline, thinner, alcohol etc. these kind of
18.
chemical material, are not allowed to use, water or soap are recommended!
In case of damages the replacement of the plug or the supply cord shall always be carried out by the
19.
manufacturer of the tool or his service organization
3. Assembly
Name of the parts
4. Operation instructions
Prior to operation
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up use of this products.
1. Power source
Ensure that the power source to be utilized conforms to the power requirements which
specified on the name plate of the hammer.
2. Power switch
Ensure that the power switch is in the position of OFF. If the plug is connected to power
receptacle while the power switch is in ON position, the demolition hammer will start operation
immediately, which can cause serious accident!
3. Extension cord
When the work area is removed from the power source, use an extension cord of sufficient
thickness and rated capacity. The extension cord should be kept as short as practicable.
Switch operating
Observe correct mains voltage! The voltage of the power source must agree with the voltage specified
on the type plate of the power tool.
To start the power tool, Press the switch towards
Switch ON
arrow "I" direction
Switch OFF To switch off the power tool, Press the switch
towards arrow "0" direction.
7
Advertisement
