Warning Notices On The Device - Fronius Virtual Welding 2.0 MobileCase Operating Instructions Manual

The device is intended for welding simulation only with the software and hardware supplied
by the manufacturer.
Any use above and beyond this purpose is deemed improper.
The manufacturer shall not be held liable for any damage arising from such usage.
Intended use also means:
-
-
-
-
-
The device must never be:
-
-
-
-
The device is designed for use in a dry and enclosed environment. The manufacturer is not
liable for any damage caused by use in a different environment.
The manufacturer accepts no liability for inadequate or incorrect training results.
Warning notices Warning notices and safety symbols are affixed to the StandUp Terminal and MobileCase.
on the device These warning notices and safety symbols must not be removed or painted over. They
warn against incorrect operation, as this may result in serious injury and damage.
16
Fully reading and understanding all the instructions given in the Operating Instructions
Fully reading and understanding all warning notices on the device
Performing all stipulated inspection and servicing work
Establishing the mains connection according to the specifications on the rating plate
Setting up in a dry and enclosed environment
Modified without authorisation
Handled improperly
Operated with software other than that supplied by the manufacturer
Operated, maintained or repaired without observing the Operating Instructions