Table of Contents
Advertisement
7. Before first use
• Clean the device prior to its first use (see
"Cleaning and storage" on page 20)!
• Remove the protective film from the operating pan-
el 10.
NOTE: because the device is slightly greased when deliv-
ered, slight smoke and odour may be produced during its
first use. This is harmless and stops after a short amount of
time. Please ensure sufficient ventilation in the meantime.
8. Handling of the Multi-Pot
8.1 Opening lid (when cold)
Figure B:
1.
Hold down the release button 24 while you turn the
lid 5 clockwise until the arrow marking 6 points to
the marking
19.
2.
Remove the lid 5 upwards.
8.2 Placing lid in drip-dry position
Figure C: for example to drip-dry the hot lid, you can
place the lid 5 upright with the tab 4 in the recess in one
of the handles 20 of the base unit 17.
8.3 Closing lid
Figure D:
For pressure to be able to build up in the Multi-Pot, it is im-
portant that the lid 5 is closed correctly.
1.
Place the lid 5 with the arrow marking
to the marking
2.
Turn the lid 5 anticlockwise until the arrow
marking
6 points to the marking
ing mechanism will click audibly.
NOTE: when the lid 5 is on top of the base unit but not
correctly closed, signal sounds will be heard and the dis-
play 29 will show Lid.
6 pointing
19.
9. The lock-
8.4 Opening/closing pressure valve
DANGER! Risk of injury from scalding!
Ensure that no body parts (e.g. hand or arm) are
above the pressure valve 1 when you open this using
the pressure valve button
There is a danger of being scalded by escaping
steam.
The pressure valve button
close the pressure valve 1.
Opening
• Press down the pressure
valve button
2 until it
clicks into place.
8.5 Pressure indicator
DANGER! Risk of injury from scalding!
Before each use, you must check to ensure that the un-
derside of the pressure indicator 27 is clean and
moves freely (see "Preparations before each use" on
page 13).
Ensure that no body parts (e.g. hand or arm) are
above the pressure indicator 23 when steam escapes
from it.
The pressure indicator 23 is a valve located in a recess in
the lid 5. Hot steam can flow out of this valve when pres-
sure has built up inside the Multi-Pot. You can see that the
Multi-Pot is pressurised when the pressure indicator 23 is
lifted.
2 and steam escapes.
2 allows you to open and
Closing
• Press down the pressure
valve button
2 so
that it disengages.
GB
11
Hide quick links:
Advertisement
Table of Contents
