Table of Contents
Advertisement
Task
Clean under the
bottom-out bumper
Clean shock absorber
exterior
Check the assembly for
leaks or loose
components
Check the shaft for
damage or rust
Check the seal head for
leaks or loosening
Check all mounting
hardware for tightness
Check eyelet bushings/
bearings
Check spring and
spring seats
Change oil, piston and
wear band, clean
interior parts, check
nitrogen pressure*
*Must be performed by Shock Manufacturer Service Department or an Authorized Shock Service Center
General Lubrication
Cables
None of the cables require lubrication;
however, it is advisable to lubricate the
ends of the cables periodically with a
good cable lubricant.
Engine Oil and Filter
Change
Change the engine oil and oil filter at the
scheduled intervals. The engine should
always be warm when the oil is changed
so the oil will drain easily and completely.
NOTE: The rear cargo tray must
be removed to access the oil tank
and top of the engine.
1. Park the vehicle on level ground.
2. Loosen the oil level stick. Be careful
not to allow contaminants to enter the
opening.
After each use
Yes
Yes
Inspect
Inspect
Inspect
Inspect
Inspect
Inspect
Every 6 months or every year, depending upon usage
End of each season
Yes
Yes
Inspect
Inspect
Inspect/Replace*
Inspect
Inspect
Inspect
3. Loosen the fill plug on top of the
valve cover. Be careful not to allow
contaminants to enter the opening.
4. Remove the drain plug and crush
washer from the bottom of the oil
tank. Use a funnel to direct the oil
into a drain pan.
Annually
Yes
Yes
Inspect
Inspect
Inspect/Replace*
Inspect
Inspect
Inspect
XX119
XX051
43
Advertisement
Table of Contents
