Muffler/Spark Arrester; Light Bulb Replacement - Tracker Off-Road 600 Operator'smanual

7. Using a crisscross pattern, tighten the
lug nuts in 20 ft-lb (27.2 N-m) incre-
ments to a final torque of 40 ft-lb
(54.4 N-m) (steel wheel), 60 ft-lb
(81.6 N-m) (aluminum wheel w/
black nuts), or 80 ft-lb (108.8 N-m)
(aluminum wheel w/chrome nuts).
8. Remove the jack.

Muffler/Spark Arrester

The muffler has a spark arrester which
must be periodically cleaned. At the
intervals shown in the Maintenance
Schedule, clean the spark arrester using
the following procedure.
! WARNING
Wait until the muffler cools to avoid
burns.
1. Remove the cap screws securing the
spark arrester assembly to the muffler.
2. Using a suitable brush, clean the car-
bon deposits from the screen taking
care not to damage the screen.

NOTE: If the screen or gasket is
damaged in any way, it must be
replaced.
3. Install the spark arrester assembly
and secure with the cap screw.
Tighten cap screw to 96 in.-lb (10.8
N-m).

Light Bulb Replacement

Taillight
To replace the taillight, use the following
procedure:

NOTE: The taillight is a non-ser-
viceable component; it must be
replaced as an assembly.
64
1. Disconnect the wiring harness and
remove the two screws securing the
taillight; then discard the old taillight.
2. Insert the new taillight into position
and secure with existing screws.
Tighten the screws securely; then
connect the wiring harness.
Headlight
Use only specified bulbs indicated in
the Specifications chart as replace-
ment bulbs.

NOTE: The bulb portion of the
headlight is fragile. HANDLE WITH
CARE. When replacing the head-
light bulb, do not touch the glass
portion of the bulb. If the glass is
touched, it must be cleaned with a
dry cloth before installing. Skin oil
residue on the bulb will shorten the
OHA034
life of the bulb.
To replace the headlight bulb, use the fol-
lowing procedure:
1. Disconnect the wiring harness; then
remove the rubber boot from the light
assembly.
CAUTION
OHA036
MOD046