Table of Contents
Advertisement
3. Install the new taillight/brake light
assembly and secure with the screws.
Tighten securely; then connect the
electrical connector.
Checking/Adjusting
Headlight Aim
The headlights can be adjusted vertically.
The geometric center of the HIGH beam
light zone is to be used for vertical aim-
ing.
1. Position the vehicle on a level floor
so the headlights are approximately
6.1 m (20 ft) from an aiming surface
(wall or similar aiming surface).
NOTE: There should be an aver-
age operating load on the vehicle
when adjusting the headlight aim.
2. Measure the distance from the floor
to the midpoint of each headlight.
3. Using the measurements obtained in
step 2, make a horizontal mark on the
aiming surface directly in front of
each headlight.
4. Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
56
5. Observe each headlight beam aim.
Proper aim is when the most intense
beam is 5 cm (2 in.) below the hori-
zontal mark on the aiming surface.
6. Adjust each headlight until correct aim
is obtained by loosening (counterclock-
wise) the retaining knob located under-
neath the hood in front of the radiator,
then pivoting the assembly up or down.
Once the correct level is achieved,
WC099A
tighten (clockwise) the knob.
Power Distribution
Module (PDM)
The fuses, relays and a resistor are
located in two separate power distribu-
tion modules under the battery access
cover between the seats. If there is any
type of electrical system failure, always
check the fuses first.
XX029
NOTE: To access the fuses, com-
press the locking tabs on either
side of the fuse cover and lift the
cover from the PDM.
XX120
XX125
6411-050
Advertisement
Table of Contents
