Table of Contents
Advertisement
CAUTION
Do not attempt to either engage or
disengage the front differential lock
while the vehicle is moving.
NOTE: When the differential lock
is engaged, the LOCK icon will be
illuminated on the digital gauge.
NOTE: The differential lock is
intended for use where minimum
traction is available. Steering effort
will increase with the front differen-
tial lock engaged. Maneuverability
and handling characteristics will
differ with the differential lock
engaged.
Foot Brake
The foot brake is the only service brake,
and it should be applied whenever brak-
ing is needed.
Apply the brake by pressing the brake
pedal down.
Steering Wheel Tilt Lever
Pull on the lever located on the steering
column and move the steering wheel to
the desired position; then release the
lever and make sure the steering wheel
locks securely.
! WARNING
Make sure the steering wheel is locked
securely in place before moving the
vehicle, or steering wheel movement
could occur causing loss of control.
Headlight Switch
Use the headlight switch to select the LED
light strip, low beam with LED or high
beam with LED.When the switch is in the
LED position only, the light strip will illu-
minate. When the switch is in the low
beam position, the low beam will illumi-
nate along with the LED light strip. When
the switch is in the high beam position, the
high beam will illuminate along with the
LED light strip.
Accelerator Pedal
Press down on the pedal to increase
engine RPM and vehicle speed; release
the pedal to decrease engine RPM and
vehicle speed.
NOTE: This vehicle is equipped
with an RPM limiter that retards
ignition
RPM is approached. When the RPM
limiter is activated, it could be mis-
interpreted as a high-speed misfire.
Seat Latches
1. To remove the seat, lift up on the
latch release (located at the rear of the
seat); then raise the rear of the seat
and tilt it forward.
XX005A
timing
when
XX121
maximum
WC017A
27
Advertisement
Table of Contents
