Oil Level Stick - Tracker Off-Road XTR1000 Operator's Manual

Display Fault Description
P0630 VIN Not Programmed or Incompatible
P0641 Sensor Reference Voltage #1 Circuit
Low/Open
P0643 Sensor Reference Voltage #1 Circuit
High
P0651 Sensor Reference Voltage #2 Circuit
Low/Open
P0653 Sensor Reference Voltage #2 Circuit
High
P0685 EFI/Main Relay Circuit Open
P0686 EFI/Main Relay Circuit Low/SG
P0687 EFI/Main Relay Circuit High/SP
P0691 Fan-Primary Relay Control Circuit
Low/SG
P0692 Fan-Primary Relay Control Circuit
High/SP
P0693 Fan-Secondary Relay Control Circuit
Low/SG
P0694 Fan-Secondary Relay Control Circuit
High/SP
P1120 Throttle Position Sensor Lower
Position
P1121 Throttle Position Sensor Lower
Adaption
P1122 Throttle Position Sensor Lower Return
P1123 Throttle Position Sensor Adaption
Condition
P1124 Throttle Position Sensor Limp Home
Adaption
P1125 Throttle Position Sensor Upper
Position
P1126 Throttle Position Sensor Upper
Return
P2100 Throttle Actuator Control Motor Circuit
Open
P2102 Throttle Actuator #1 Control Motor
Circuit Low/SG
P2103 Throttle Actuator #1 Control Motor
Circuit High/SP
P2106 Electronic Throttle Control Output Is
Out Of Range
P2107 Electronic Throttle Control Driver
Over-Temperature
P210C Throttle Actuator #2 Control Motor
Circuit Low/SG
P210D Throttle Actuator #2 Control Motor
Circuit High/SP
P2118 Throttle Actuator Control Motor
Range Error
P2119 Throttle Control Actuator Control
Performance Error
P2122 Pedal Position Sensor #1 Circuit
Low/Open/SG
P2123 Pedal Position Sensor #1 Circuit
High/SP
Display Fault Description
P2127 Pedal Position Sensor #2 Circuit
Low/Open/SG
P2128 Pedal Position Sensor #2 Circuit
High/SP
P2135 Throttle Position Sensor Plausibility
Error
P2138 Pedal Position Sensor Plausibility
Error
P2299 Brake Pedal Position/Accelerator
Pedal Position Incompatible
P2300 Ignition Coil #1 Primary Circuit
Low/SG/Open
P2301 Ignition Coil #1 Primary Circuit High
P2303 Ignition Coil #2 Primary Circuit
Low/Open
P2304 Ignition Coil #2 Primary Circuit High
P2306 Ignition Coil #3 Primary Circuit
Low/Open
P2307 Ignition Coil #3 Primary Circuit High
P2610 ECU Warm Reset
U0100 Lost Communication with ECM
U0155 LCD Gauge to ECM CAN
Communication Lost
FUEL Tilt Sensor Activation Code
OFF

Oil Level Stick

There is an oil level stick for checking
the engine oil level. To check the oil
level, use the following procedure.

NOTE: Engine oil level must be
checked at normal operating tem-
perature and on level ground.
! WARNING
Use caution when removing oil level
stick. Exhaust components may be
extremely hot.
1. Start the engine and allow it to warm
up for several minutes. Let idle until
it achieves full operating temperature
(at least one of the radiator fans
cycles on and off) or take vehicle for
a short drive to achieve full operating
temperature.
2. Let the engine idle for at least 10 sec-
onds before shutting off.
3. Although it is possible to access the oil
tank dipstick with the rear cargo tray in
place, it is recommended to remove the
rear cargo tray (see the Rear Cargo
Tray Removal/Install section).
33