General Information; Control Locations And Functions - Tracker Off-Road XTR1000 Operator's Manual

General Information

Control Locations and
Functions
Ignition Switch Key
Two keys come with this vehicle. Keep the
spare key in a safe place. An identifying
number is stamped on each key. Use this
number when ordering a replacement key.
Ignition Switch
The ignition switch has three positions.
OFF position — All electrical circuits except
accessory are off. The engine will not start.
The key can be removed in this position.

NOTE: The accessory plugs are
powered by the battery at all times.
RUN position — The ignition circuit is
complete and the engine can run. The key
cannot be removed in this position.
START position — The ignition circuit
is complete and the starter is engaged.
When the key is released, the switch will
return to the RUN position. The key can-
not be removed in this position.

NOTE: This vehicle has safety
interlock switches which prevent
the starter motor from activating
when the transmission is in gear.
Depress and hold the brake pedal
to engage starter when the trans-
mission is not in park or neutral.
Shift Lever
This vehicle has a dual-range automatic
transmission with reverse and park.
26
Drive Select Switch
ATV-0056A
This switch allows the operator to oper-
ate the vehicle in either two-wheel drive
(rear wheels) or four-wheel drive (all
wheels) as well as mechanically lock the
differential to apply equal power to both
front wheels. For normal riding on flat,
dry, and hard surfaces, two-wheel drive
should be sufficient. In situations when
additional traction is necessary, four-
wheel drive would be the desired choice.
To select 2WD, depress the bottom of the
switch. To select 4WD, move the switch
to the middle position. To engage the dif-
ferential lock, slide the switch latch
slightly downward while pressing the top
of the switch forward.
XX004
XX008A
XX008B