Advertisement
Step 9: Leveling and Tension
Once the television is mounted onto the NPT Tube (b), and the Security Bolt (i) is tight, it can be adjusted to level. Slightly loosen the
two allen bolts on the back of the Axis Assembly (c). Once those two bolts are loosened, the television can be adjusted ±6° until level.
When the television is level retighten the two allen bolts. The tilt can be adjusted by simply tilting the television. To increase or decrease
tension of the tilt, loosen the knobs that are labeled in Diagram 9. The Nut in the Detailed View can be slightly tightened or loosened to
adjust the tension of the Swivel. Once you have tilted the TV forward and removed the Safety Bracket, you can use the Safety Bracket
to adjust the tension. Make sure a flat side of the tension nut is parallel with the TV before putting the Safety Bracket back on.
Detailed View
tension
nut
Step 10: Cable Management
Leave some slack in the cables so that during motion there is no added tension on the connectors. There are several places to attach Wire
Ties to keep cables out of the way. You can attach them to the holes in the sides of the Monitor Brackets (f), the Axis Assembly (c) or
around the NPT Tube (b). See Diagram 10 for assistance.
k
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
Adjust Swivel Tension
Detailed View
Sanus Systems 2221 Hwy 36 West, St. Paul, MN 55113 10.18.05
tension
knobs
f
Diagram 10
Diagram 9
allen
bolts
Advertisement
