Advertisement
Step 3: Add the Vise Assemblies to the Monitor Brackets:
Note: Do not overtighten the 1/4-20 Nut. The Vise Assembly should be able to rotate freely around the Carriage
Bolt.
Place the Vise Assembly (e) between the two sides of the Monitor Bracket (f) so that the two jaws point toward the set of 1" diameter
holes and the allen bolt is facing away from the television as shown in the Detailed View of Diagram 3. Place a Carriage Bolt (g) through
the square hole in the side of the Monitor Bracket, through the hole in the Vise Assembly, and then through the square hole in the other
side of the Monitor Bracket also shown in Diagram 3. Next, tighten a 1/4-20 Nut (h) onto the end of the Carriage bolt. Repeat this step
for the bottom of the Monitor Bracket. Finally, repeat these two steps for the second Monitor Bracket.
Step 4: Attach the Axis Assembly to the Television
Warning: The 1" Diameter Tubes must extend beyond the outside edges of both Monitor Brackets and the Allen
Bolts in all 6 Vise Assemblies must be tightened for the installation to be safe!
First, orient each Vise Assembly (e) so that a 1" Diameter Tube (d) will pass through the 1" round hole in the Monitor Bracket (f) and
then between the jaws of the Vise Assembly. Insert a 1" Diameter Tube through the top hole in the first Monitor Bracket as shown in
Diagram 4. Repeat this step for the Bottom hole in the same Monitor Bracket.
Diagram 3
Diagram 4
d
f
e
Detailed View
f
g
allen bolt
e
h
Advertisement
