problem
Der Scanner funktio-
niert nicht
scanner can't scan or
delete barcode
PC doesn't recognize
scanner
LCD display
green - flashing
during process of scanning
green - steadily
during process of scanning
red – steadily
during process of scanning
red – steadily
during process of deleting
orange – flashing
during process of deleting
orange - steadily
during process of deleting
red – steadily
during process of charging
green – steadily
during process of charging
red / green – flashing
Version REV-00
problem solving
possible cause
suggested solution
batteries are dead
charge battery by connecting to PC
scanner is broken
send in scanner to your supplier
barcode is defective
test scanner on other barcode
distance or ankle
place beam vertically on barcode and modify the
doesn't fit
distance
scanner is connected
if the scanner is connected to PC, no codes can be
to PC
scanned. Unplug scanner to gather data.
memory is full
if more than 150 articles are scanned, data has to be
transferred to the PC or deleted
cable unplugged
check if cable and adaptor is connected properly to
PC
PopScan-driver not
install the driver again
properly installed
meaning of LCD-display
meaning
scan button is pressed and laser beam is on
if the beam hits a barcode, it will be read and saved in the scanner
barcode is correctly read and saved in the scanner
barcode is correctly read, but storage is full. NO data storage possi-
ble, please transfer data!
barcode is correctly read, but not available in storage and therefore
cannot be deleted.
The minus button is pushed. If the beam aims a barcode, the bar-
code will be read and deleted!
The minus button was pushed for more than 6 secons. All saved
data will be deleted.
battery is charging
battery is fully charged
battery may be faulty or exhausted. Please return the OPN2001 to
your supplier.
11