Konica Minolta bizhub C352 Installation Manual page 13

XXI. Adjusting Registration of Paper
Source Options
<1 Way Paper Feed Cabinet, Large Capacity Cabi-
net>
1. Display the Service Mode screen.
(For details of how to display the Service Mode
screen, see the service manual.)
2. Select the function to be used as follows:
Machine → Printer Area
→ Print Positioning: Side Edge → 3rd.
3. Press the start key.
A test print will be produced.
4. Measure width A from the edge of the paper to
the pattern printed on the test print and check that
it falls within the specified range.
Specifications: 3.0 mm ± 1.0 mm
Paper Exit
Direction
A
5. If the measured width A falls outside the specified
range, enter the correction value using the
or key.
6. Produce another test print and check to see if
width A falls within the specified range.
7. Select the function to be used as follows:
DUP Print Positioning: Side Edge → 3rd.
8. Press the start key.
A test print will be produced.
9. Measure width A of the test pattern on the back-
side of the test print produced and check that it
falls within the specified range.
Specifications: 3.0 mm ± 2.0 mm
4037IXE322DA
Paper Exit
Direction
10. If the measured width A falls outside the speci-
fied range, enter the correction value using the
or
11. Produce another test print and check to see if
width A falls within the specified range.
12. Touch "END."
13. Touch "Exit" on the Service Mode screen.
14. Turn OFF and ON the Main Power Switch.
4061IXC147DA
Note:
When displayed the Service Mode screen, be sure
to turn off the main power after exiting the Service
Mode screen and wait for 10 seconds or more
before turning on.
E-13
A
key.
4037IXE323DA
4061IXC152DA