Table of Contents
Advertisement
Installation
i
NtroDuCtioN
h
aNDliNg aND
s
torage
p
ositioN of
C
ompoNeNts
a
pprovals of
C
ompoNeNts
8
In this section you will find the information and instructions needed
to install the burner and system components.
Handling
•
Make sure the area is clean
•
Protect the components from weather, damage, dirt and
moisture
•
Protect the components from excessive temperatures and
humidity
Storage
•
Make sure the components are clean and free of damage
•
Store the components in a cool, clean, dry room
•
After making sure everything is present and in good condition,
keep the components in original packages as long as possible
The position and amount of components are determined by the
kind of control method chosen. All the control methods can be
found in Design Guide 230, Chapter 3 "System Design". Use the
schematics in that chapter to build your system.
Limit Controls and Safety Equipment
All limit controls and safety equipment must comply with the
current following standards:
•
NFPA Standard 86
•
NFPA Standard 86C
•
UL
•
FM
•
CGA
•
EN 746-2
•
All applicable local codes and/or standards
Electrical Wiring
All electrical wiring must comply with all applicable local codes
and/or standards, which may include:
•
NFPA Standard 70
•
ANSI-C11981
•
EN 746-2
Gas Piping
All gas piping must comply with all applicable local codes and/or
standards, which may include:
•
NFPA Standard 54
•
ANSI Z223
•
EN 746-2
Eclipse ExtensoJet v2 Installation Guide No. 230, 9/17/2008
3
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the ExtensoJet EJ025 and is the answer not in the manual?
Questions and answers