Preparing The Burner - Eclipse ExtensoJet EJ025 Installation Manual

p b
repare the urNer
1
4
4
Rotate the Rear Cover (Optional)
Spark Plug
Installing the Flame Sensor
10
Several components must be installed on a burner before it can
operate. Installation instructions follow:
It is possible to change the relative position of the gas inlet with
respect to the air inlet. This can be convenient for the routing of
the piping.
To rotate the rear cover, do the following steps:
1. Disconnect the piping at a union in the piping or the inlet
flanges
Note:
Be careful not to lose or damage the orifice plate or the
O-rings.
2. Remove the four bolts
3. Remove the rear cover
4. Rotate the rear cover
5. Put the rear cover in position against the burner housing
3
6. Install the four bolts
2
7. Reconnect the piping. Make sure that the O-rings show no
signs of damage.
3
2
Installing the Flame Sensor
1. Install the flame sensor into the 1/2" NPT opening in the rear
cover.
2. Make sure that you connect the flame sensor of a burner to
Flame Rod
the electrical circuit of that burner.
Danger:
If you connect the flame sensor of a burner to the
electrical circuit of the wrong burner, then you can
cause fires and explosions.

provided on the burner.

.

from the burner housing

to the position that you want.

.
Eclipse ExtensoJet v2 Installation Guide No. 230, 9/17/2008

.

.