Page 2
Please send your corrections and comments to our Marketing Communications Manager. www.eclipsenet.com It must be understood that Eclipse’s liability for its product, Product Name whether due to breach of warranty, negligence, strict Item # liability, or otherwise is limited to the furnishing of replacement parts.
Step 4: Flame Monitoring Control System................9 Step 5: Combustion Air System ................... 9 Step 6: Main Gas Shut-Off Valve Train ................10 Appendix ........................... i Conversion Factors ......................i Key to System Schematics....................ii Eclipse ThermJet Self-Recuperative, V5, Design Guide 208, 9/16/2011...
UL, FM, CSA, ■ The burner and duct sections are likely to have CGA and/or CE approvals where applicable. HOT surfaces. Always wear protective clothing when approaching the burner. ■ Eclipse products are designed to minimize the use materials that contain crystalline silica.
• Desired Efficiency performance characteristics. Use the control circuits • Fuel Type and Pressure contained within this section or contact Eclipse for written, approved alternatives. 2. Control Methodology Control Method 3. Ignition System Eclipse recommends the high/low pulse method to control 4.
Page 7
Shut-Off Valve Train To Other Zones To Other Zones High/Low Control (multiple burners, shut-off by burner) Main Gas Shut-Off Valve Train To Other To Individual Zones Burner Piping Figure 3.1 High/Low Control Eclipse ThermJet Self-Recuperative, V5, Design Guide 208, 9/16/2011...
Page 8
Shut-Off Valve Train To Other Zones To Other Zones High/Low/Off Control (Multiple burners, shut-off by burner) Main Gas Shut-Off Valve Train To Individual To Other Burner Piping Zones Figure 3.2 High/Low/Off Control Eclipse ThermJet Self-Recuperative, V5, Design Guide 208, 9/16/2011...
• half-wave transformer determine how burner performance may be affected. Flame monitoring controls that have lower sensitivity Eclipse recommends a low fire start be used. However, flame detecting circuits may limit burner turndown and ThermJet Self-Recuperative burners are capable of direct change the requirements for ignition.
The volume of air required will be dictated by the maximum output required from the burner. This will be Eclipse can help you design and obtain a main gas shut- the total of the air required for combustion plus the air off valve train that complies with the current safety required for the eductor.
Name Remarks Info Guide ThermJet Self-Recuperative Burner Main gas Main Gas Shut-Off Valve Eclipse strongly endorses NFPA as a minimum shut-off Train valve train The combustion air blower provides the combustion air Combustion Air Blower pressure to the burner(s) The air pressure switch gives a signal to the safety...