Preliminary Work; Heater Installation Location; Pwm Gateway And K2 Relay 1 - Webasto Thermo Top Evo Installation Documentation

Citroen C4 Picasso

Preliminary Work

Vehicle
• Open the fuel tank cap.
• Ventilate the fuel tank.
• Close the fuel tank cap again.
• Depressurise the cooling system.
• Remove the windscreen wiper.
• Remove the coolant reservoir cap.
• Remove the cowl cover on the engine side.
• Disconnect and completely remove the battery with carrier.
• Remove the air filter box completely.
• Remove the left front wheel.
• Remove the left-hand wheel well trim.
• Remove the lower engine cover (if present).
• Remove the right rear underride protection.
• Remove the horn.
• Remove the A-pillar trim on the driver's side (only with Telestart).
• Remove the lower instrument panel trim on the driver's and front passenger's side.
• Remove the instrument panel trim on the right side (see installation instructions).
• Remove the lateral instrument panel trim of the centre console on the front passenger's side (see installation in-
structions).
• Remove the glove compartment (see installation instructions).
• Remove the middle rear seat.
• Remove the fuel-tank sending unit in accordance with the manufacturer's instructions.
Heater
• Remove years that do not apply from the type and duplicate label.
• Attach the duplicate label (type label) in the appropriate place in the engine compartment.
1
Ident. No.: 1321285E_EN

Heater Installation Location

1 Heater
1
Status: 30.04.2014
Installation
location
© Webasto Thermo & Comfort SE 5