Advertisement
Safety Precautions:
● Work in a well-ventilated area that is clear of obstructions.
● Secure vehicle with tire chucks in both front and rear of tires.
● Turn vehicle accessories OFF and ensure ignition key is in OFF position.
● Wear safety goggles and snug fitting clothes.
● Use tools only for their intended purpose and which are in good repair.
● Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com
Installing Monitor
1. The RED wire connects to accessory power.
2. The BLACK wire connects to ground.
3. GREEN wire connects to the vehicle's 12-volt
reverse wire. (If the camera is needed to turn
on only in reverse. If the camera is wanted on
at all times then do not connect green wire.)
4. Connect the power harness to the monitor.
5. Connect the video input harness to the power
harness. If using the display for a backup
INSTALLATION: Rear camera
1. Remove the 4 Allen screws that are located
on the sides of the camera. Then remove
the camera mounting bracket and visor.
2. Find an appropriate place to mount the
backup camera. Line up the foot bracket to
ensure that there is enough space to attach
the camera to the body.
3. Attach the mounting foot using either self-
tapping screws or a bolt and nut.
9002-7702 Instructions 04-19-2017.docx
INSTALLATION INSTRUCTIONS
camera, connect to CAM2. It will trigger off the
reverse.
6. CAM1 can be used for "always on" video input.
7. The Allen wrench is used for screws that allow
you to "lock" the mounting bracket in position.
8. Connect the camera 4-pin harness to the
Monitors 4-pin camera input. (No power will be
needed for the camera, the camera receives
power from the monitor.)
4. Use a 1" hole saw to drill a hole for the
camera harness.
5. Then feed the harness through the drilled
hole, fit the grommet to the inside of the
hole.
6. Reattach camera and visor to the mounting
bracket. Make sure the camera is oriented
UP by seeing the light sensor on the right
side of the camera when looking at it.
7. To turn off the guidelines connect the white
wire loop on the camera harness.
Page 2 of 3
KB
Advertisement
