Advertisement
Safety Precautions:
● Work in a well-ventilated area that is clear of obstructions.
● Secure vehicle with tire chucks in both front and rear of tires.
● Turn vehicle accessories OFF and ensure ignition key is in OFF position.
● Wear safety goggles and snug fitting clothes.
● Use tools only for their intended purpose and which are in good repair.
● Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com
INSTALLATION: Camera
1. Remove the 4 Allen screws that are located
on the sides of the camera. Then remove
the camera mounting bracket and visor.
2. Find an appropriate place to mount the
backup camera. Line up the foot bracket to
ensure that there is enough space to attach
the camera to the body.
3. Attach the mounting foot using either self-
tapping screws or a bolt and nut.
4. Use a 1" hole saw to drill a hole for the
camera harness.
5. Then feed the harness through the drilled
hole, fit the grommet to the inside of the
hole.
6. Reattach camera and visor to the mounting
bracket. Make sure the camera is oriented
9002-7701 Instructions 04-19-2017.docx
INSTALLATION INSTRUCTIONS
7. UP by seeing the light sensor on the right
side of the camera when looking at it.
8. Route the camera harness to the front of
the vehicle where the display is located.
9. Connect the 4-pin to RCA cable to the end
of the harness at the display end.
10. Connect the RED to 12-volt accessory
11. Connect the BLACK to ground.
12. The YELLOW RCA is video output.
13. The WHITE RCA is audio output.
14. The BLACK connector if for the power plug.
15. To turn off the guidelines connect the white
wire loop on the camera harness.
Page 2 of 3
KB
Advertisement
