Advertisement
1. Remove the third brake light from the back
of the Sprinter.
2. Apply the foam gasket to the vehicle around
the opening of the light.
3. Connect the chassis harness to the camera
and run forward to the dash.
4. Connect the chassis harness to the power
video harness.
5. Remove the trim around the radio with a
plastic panel removal tool.
6. Remove the (4) Torx screws from around
the radio.
7. Plug the FAKRA to RCA into the green plug
on the back of the radio. If there is a plug
in there, remove and leave unplugged.
8. Connect the RCA end of the FAKRA to the
male to male RCA adapter and other side of
the adapter to the yellow video RCA from
the camera.
9. Connect accessory power and ground to the
red and black wires on the camera power
harness.
9002-7710 v1 10-19-2016.doc
INSTALLATION INSTRUCTIONS
10. Use the power point below the radio
11. Open OBD connector cover/ fuse box cover
12. Plug in the OBD Flash Module to the OBD
13. Turn the key to the ignition position.
14. Wait for the radio screen to display the
15. Check to see if camera image is displaying
16. If there is no camera image on the screen:
17. Press OK to return back to the radio screen.
18. Remove the OBD Flash Module and close
19. Store the OBD Flash Module in vehicle glove
20. With the vehicle started, depress the brake
21. Reinstall the radio screws and trim.
22. Reassemble any panel that where taking
Page 2 of 2
(cigarette lighter) for power and ground.
at the lower left side of the dash.
connector.
"diagnosis" check. ("WARNING- DO NOT
LET THE SYSTEM DISTRACT YOU FROM
THE TRAFFIC SITUATION.")
on the screen.
go to System, press OK, then select
Camera, press OK. The display should now
show the camera image.
the cover.
box.
pedal and put the vehicle into reverse to
see the camera image on the radio display
screen.
apart for the installation.
GS
Advertisement
