Maintenance - Husky 33056 Assembly, Installation, Operation And Maintenance Instructions

1. After coupling, always visually check that the 5
the rear of the king pin and that the indicators are working properly.
IMPORTANT! All indicating features must work when you are done hitching up for travel.
2. After the first 100 miles, and at least once a year thereafter, inspect all bolts for proper tightness. Re-
tighten nuts if needed.
3. Once or twice a week when traveling, apply a few drops of lubricant to the pivot areas of the hitch.
4. Once or twice a year, apply a light coating of wheel bearing grease to the surfaces of the slide bar that
holds the king pin in place. For best results, apply the grease with the slide bar or jaw surfaces of the
th
5 wheel in the closed position.
th
Caution: The 5
fingers, hands, extremities & clothing out of the path of the slide bar. Failure to do so could
result in severe injury.
5. Periodically inspect your product for wear or damage. If excessive wear or damage is found, contact
your installing dealer or HUSKY technical support staff at
6. Husky Towing Products recommends the use of a lube disc, contact your local Husky dealer to
purchase one.
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information /
Tech Support / Product Updates. ©2017 DTS Manufacturing. All Rights Reserved. August 2, 2017‐Rev3 Page‐7
wheel jaw or slide bar can close with heavy force. Use extreme care to keep

Maintenance

th
wheel jaw or slide bar has closed completely across
www.huskytow.com or 1-877-544-4449.